SUBARU REV LIMITER WITH LAUNCH CONTROL SYSTEM
ACCURATE MICROPROCESSOR CONTROLLED
Our Rev-Limiter is designed to prevent engine over speed by cutting the ignition spark by the user at the required RPM level
The launch control system can produce a flame and very high noise levels at the exhaust tail pipe which is a result of the unburnt fuel being ignited, this is not a design feature but a result of the systems operation
Please note that the flame will not be produced with vehicles still using the catalytic converter which can be damaged if used for extended periods
WITH BASIC WIRING AND FITTING INSTRUCTIONS
EASY TO FIT AND SET UP
FOR COIL PACK IGNITION SYSTEMS CENTRE AND RIGHT SIDE MOUNTED
HAS A LAUNCH CONTROL FACILITY AND COMES WITH THE BUTTON TO OPERATE IT
Protect Your Engine
At a user definable engine speed, a selectable hard ignition cut rev limit reduces engine power safely to limit the engine speed, protecting your engine from damage caused by over-revving
Consistent Faster Starts
A launch control limit is user definable and operated with the supplied launch button to give consistent starts, reducing wheelspin or engine 'bog down'.
With turbocharged engines this allows you to build boost at low engine speeds for the launch
A Rev Limiter With Full Throttle Gearshift Panel Mounting Design
Our high performance rev limiter in addition offers full throttle gearshift capabilities.
This function limits the engine speed during gearshifts, allowing a gearshift to be made without closing the throttle.
The unit is supplied with a clutch switch as below and in addition can be used with the launch control push switch together
Rev Range
2 Cyl 1,000RPM-20,000RPM
4 Cyl 1,000RPM-20,000RPM
6 Cyl 1,000RPM-12,000RPM
8 Cyl 1,000RPM-10,000RPM
Whats In The Box?
Rev Limiter with Launch Control unit
Launch control button and instructions
Clutch switch
Terminal, screw and spring washer for earth connection
‘T’ crimp connections for joining to existing wiring
Cable ties to route the wiring
User instructions manual
Control Unit Dimensions Are 70mm X 44mm X 14mm
Compatibility
Non-amplified and externally amplified ignition coil packs 2 4 6 or 8 cylinders
DESIGNED AND MANUFACTURED IN THE UNITED KINGDOM